Customized evaporator motor factory shares the key points of evaporation safety operation
- Categories:Evaporator motor
- Author:
- Origin:
- Time of issue:2022-06-23
- Views:0
(Summary description)1. Customized evaporator motor factory recommends strictly controlling the liquid level of each effect separator to make it in a suitable position for process requirements.
Customized evaporator motor factory shares the key points of evaporation safety operation
(Summary description)1. Customized evaporator motor factory recommends strictly controlling the liquid level of each effect separator to make it in a suitable position for process requirements.
- Categories:Evaporator motor
- Author:
- Origin:
- Time of issue:2022-06-23
- Views:0
1. Customized evaporator motor factory recommends strictly controlling the liquid level of each effect separator to make it in a suitable position for process requirements.
2. When evaporating materials that are easy to precipitate and crystallize, scaling and blockage of pipelines, plate evaporators, valves, etc. are prone to occur.
3. Customized evaporator motor factory reminds to adjust the instrument frequently to make it sensitive and reliable.
4. Always carry out strict inspection and flaw detection on equipment and pipelines, especially the sight glass glass should be checked frequently and replaced in time to prevent accidents caused by corrosion.
5. Customized evaporator motor factory thinks that before overhauling the equipment, it is necessary to release the pressure and discharge the material, and rinse with water to cool down to remove the residual corrosive liquid in the equipment.
6. Operators and maintenance personnel should wear protective clothing to avoid personal injury caused by hot liquid and hot steam.
7. The customized evaporator motor factory believes that when disassembling the flange screws, the corners should be disassembled or tightened, and follow the steps, especially when disassembling, confirm that there is no liquid before disassembling, so as to avoid liquid spraying, and pay attention to the underside of the nozzle can not be removed. someone.
8. When overhauling the evaporator, the material should be drained cleanly, washed with hot water, and then washed out with cold water.
9. After the evaporator of the customized evaporator motor factory discharges water, open the manhole to allow the air to be replaced and cool down to below 36 °C. At this time, the maintenance personnel can wear clothes and enter the maintenance, and there needs to be someone outside to monitor, so as to facilitate timely rescue in the event of an accident.
Scan the QR code to read on your phone
Relevant news






Feedback
E - motor Co., LTD
E-mail:emotor8@163.com
Tel:0757-2551 7555 sale:0757-2550 3709
Fax:0757-2551 4567
Add:Building B/C,ADlO Industrial Zone,Shapu,Jun’an,TownShundeDistrict,Foshan City,China

Wechat applet

WeChat official
E - motor Co., LTD Copyright © 2021 All rights reserved 粤ICP备14032482号
Powered by :www.300.cn